在社交媒体上共享

NV08C-CSM-BRD高精板卡

NV08C-CSM-BRD: 

多系统、多通道、混合定位GNSS接收器,

35x50x4.7mm,20针通信端口(UART通信、电源),2个MCX天线母座(有源天线、无源天线),

客户快速推出市场,

自主精度1.5米,差分<1米,RMS ,

高可用性、稳定、抗干扰、高精度。 

NV08C-BRD

特点:

• 迅速集成样品

• GPS,GLONASS,北斗,GALILEO,QZSS,SBAS L1 

• 精确导航、精确定位、精确授时

• 32个GNSS跟踪通道

• 200K相关器-确保TTFF(首次定位时间)非常短、确保高信号灵敏度

• 原始数据输出-伪距载波相位多普勒

• 独立的GLONASS群时延修正,确保非常高的精度

• 辅助GNSS (A-GNSS) 定位界面

• 64 KB EEPROM内存供固件升级和数据保存

• NMEA 0183 / IEC 61162-1, 二进制 (BINR) 和RTCM SC-104 数据协议

• 接收器自主完整性监控 (RAIM)

• 工业级操作温度范围 ‐40至+85°C

数据接口:NV08C-CSM-BRD板卡有2个UART主要数据通信接口可连接主系统,支持波特率 4800~230400 bps.

数据协议:

NV08C-CSM-BRD板卡支持如下协议:

• NMEA 0183 v2.3 (IEC61162-1)

• BINR (二进制厂商私协议)

• RTCM SC 104 (语句: #1, #9, #31, #34)

 

默认设置

NV08C-CSM-BRD出厂默认设置为NMEA协议、115200 bps波特率:

语句/数据更新率: GGA/1, RMC/1, GSV/1, GSA/1, RZD/1, GBS/10 (详情请参考 NV08C接收器协议规格书)

NV08C-CSM-BRD其他设置:

• 导航工作模式: GPS和GLONASS

• RTCM数据:自动运算

• SBAS 数据: 根据需求($PONAV NMEA指令)

• RAIM: 自动

• 辅助定位数据: 自动运算

• 导航数据更新率: 1 Hz

• NMEA语句:参考协议规格书

 

原始数据精度:    •伪距观测: < 0.5m           •载波相位观测: < 1mm

定位精度:     •差分模式: < 0.5m (RMS)        •RTK/PPP mode: < 1 cm (RMS)

NV08C-BRD板卡原始数据精度质量,可以适合做RTD、RTK应用,如NV08C-RTK板卡采用了NV08C-CSM模块的原始数据。

 

NV08C-BRD原理图

NV08C-CSM-BRD High Precision GNSS Card

NV08C-CSM-BRD: The NV08C-CSM-BRD Card’s key feature is its compatibility with existing GNSS systems such as GPS and GLONASS and Satellite Based Augmentation Systems (SBAS), as well as with newly deployed GNSS systems such as GALILEO and BeiDou.

The NV08C-CSM-BRD Card features a highly sensitive receiver to capture and maintain the satellite signals, combined with low power consumption, even when receiving multiple GNSS and SBAS signals. Tracking satellites from multiple GNSS constellations and using Assisted GNSS (A-GNSS) ensures much higher availability of navigation signals, when compared to single constellation alternatives, and provides increased performance, accuracy and reliability for devices used in urban and industrial environments. The NV08C-CSM receiver includes two separate RF paths (GPS and GLONASS) and a 3-stage SAW filtration for enhanced interference immunity.

The NV08C-CSM-BRD Card provides flexible integration options, including active or passive antenna connection with automatic detection, antenna power supply and short circuit protection. 2 MCX female RF connectors and 20-pin digital & power connector on board.

Feature

The NV08C-CSM-BRD Card Features:

• Very quick and simple integration

• GPS, GLONASS, GALILEO, QZSS, COMPASS & SBAS L1

• Precise navigation, positioning and timing

• 32 GNSS tracking channels

• 200K correlators - Ensuring fast TTFF and high signal sensitivity

• Raw Data output - Pseudorange, Carrier phase and Doppler

• Individual GLONASS group delay calibration assuring very high accuracy

• Assisted GNSS (A-GNSS) interface

• 64 KB EEPROM for firmware upgrade and data storage

• NMEA 0183 / IEC 61162-1, binary (BINR) and RTCM SC-104 data protocols

• Receiver Autonomous Integrity Monitoring (RAIM)

• Industrial operating temperature range ‐40 to +85°C

Data Protocol

The NV08C-Mini PCI-E’s supported protocols are as follows:

• NMEA 0183 v2.3 (IEC61162-1)

• BINR (proprietary binary protocol)

• RTCM SC 104 (messages: #1, #9, #31, #34)

Default Device Configuration

By default, the NV08C-CSM-BRDis pre-configured to working with NMEA, 115200 bps:

messages/rates: GGA/1, RMC/1, GSV/1, GSA/1, RZD/1, GBS/10 (refer to NV08C Receivers Protocol Specification for further details)

Other NV08C-CSM-BRDdefault settings:

• Navigation mode: GPS and GLONASS

• RTCM data: accounted automatically

• SBAS data: on demand ($PONAV NMEA command)

• RAIM: automatic

• Assisted data: accounted automatically

• Navigation data update rate: 1 Hz

• NMEA messages: see the Protocol Specification document 

 

Navigation Parameters 导航参数

NV08C-BRD Navigation

 Digital & Power Connector Pinout 插针编号

NV08C-BRD Digital & Power Connector Pinout
NV08C-BRD板卡串口、电源等管脚定义

如果用电脑USB通信端口简便测试,需要TTL(+3.3V)转USB线。NV08C-BRD 可以当作NV08C-CSM开发板使用,作测试、验证。

参考:

BDR pin 1/2 Vcc------------TTL-USB Vcc

BRD pin 18 GND------------TTL-USB GND

BRD pin 11 Tx1--------------TTL-USB Rx

BRD pin 12 Rx1--------------TTL-USB Tx

NV08C-BRD connecting

自由设置支持Glonass、北斗、SBAS及组合

$PKON1,x,x,c-c,c-c,xxxx,a*hh<CR><LF>
第二个x:
GPS+GLONASS = 0
GPS+GLONASS+SBAS = 10
GPS+Beidou = 20
GPS+Beidou+SBAS = 30
NV08C-CSM从v5.0版本开始,用户可以通过指令设置支持Glonass还是北斗,同时也可以设置支持SBAS。

Download下载

产品手册Datasheet: NV08C-CSM-BRD-DS-v0.1-ENG.pdf